2-1/2" x 6 ft. Pipe Insulation, 3/4" Wall

Pipe Insulation, Insulation Material Buna-N Rubber/PVC, Installation Style Unslit, Inside Diameter 2 7/8 in, Wall Thickness 3/4 in, Overall Length 6 ft, Minimum Operating Temperature -297 Degrees F, Maximum Operating Temperature 220 Degrees F, Facing Material Unfaced, Color Black, R Value 4.3, Form Tube, For Copper Tube Size Not Applicable, For Pipe Size 2 1/2 in, Flame Spread Index 41, Smoke Developed Index 66, Foam Cell Type Closed, Plenum Rating Plenum Rated, Flexibility Flexible This product contains a chemical that is regulated under California Proposition 65. Warning: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm. -

Insul-Tube® 6'L, 3/4" Wall Thickness, 2-7/8" Nom.I.D.INSUL-TUBE® is used to retard heat gain and prevent condensation or frost formation on refrigerant lines, cold water plumbing, and chilled water systemsIt also retards heat flow for hot water plumbing, liquid heating, dual temperature piping, and many solar systemsDesigned for the HVAC and Refrigeration industryINSUL-TUBE® is non-porous, non-fibrous and resists mold growth. INSUL-TUBE® Pipe Insulation is made from a UV resistant elastomeric blendFor moderate UV exposure, no additional protective coating is neededHowever, for severe UV exposure (rooftop applications) or where optimum performance is required, 374 Protective Coating or approved jacketing or cladding should be used.SPECIFICATION COMPLIANCE ASTM C 534 Type 1 (Tubing) Grade 1, ASTM D 1056-00-2C1 New York City MEA 186-86-M VolIV USDA RequirementsUL 94-5V Flammability Classification (Recognition No.E300774) ASTM E 84 2" 25/50-tested according to UL 723 and NFPA 255 Complies with requirements of CAN/ULC S102 03FMRC Approval Guide Chapter 14 Pipe InsulationNFPA No.101 Class A RatingMeets requirements of NFPA 90A Sect2.3.3 for Supplementary Materials for Air Distribution SystemsMeets requirements of ASTM C 411 (Test Method for Hot Surface Performance of High Temperature Thermal Insulation)Meets requirements of UL 181 sections 11.0 and 16.0 (Mold Growth/Air Erosion) Sold in package quantity of 6, priced each., Lot of 6