Bullet_point: ['1. Cut and strip outer cable jacket to match the markings indicated on the connector housing.', '2. Align wires with markings on the housing. Place the wires on the contacts. Do not push the wires into slots. Wire ends must extend .250 in. {6.35mm) min. beyond contacts.', '3. Hold wires in place. Place the cover into housing.', '4. Grip the housing and cover firmly. Place pliers so that jaw flats are parallel and press evenly to close. Squeeze the plier handles until the two pieces snap into place.', '5. Slide the splices into each other until the locking latches engage the locking tabs.', '6.Coupled splices can be mounted to a stud or joist with four 4d common nails.', 'Do not re-terminate a splice if wire was previously inserted into contacts or strip insulation on the individual wires.', 'NOT for use with non-metallic sheathed cable made prior to 1990.', 'Price For: Each Standards: cULus Max. Voltage: 300V Color: White Item: Nonmetallic Splice Wire Range: 14 to 12 Temp. Range: Up to 220 Degrees F Number of Wires: 2 + Ground Material: Polyethylene Length: 4" Country of Origin (subject to change): Multiple', 'RISK OF ELECTRICAL SHOCK: Do not use where directly exposed to water.', 'To avoid electric shock, disconnect power from the circuit before proceeding.']

Products with this attribute (1 total)