DAP? '33'? ALUM-33QTW-VCP-1

<br/><b>CRL DAP? '33'? Glazing Compound</b> is smooth and flexible, and comes ready-to-use for face glazing wood and metal window frames. Its adhesion to both glass and sash is excellent, forming a dependable air and watertight seal that resists sagging, shrinking, chalking, and cracking.<br/><b>SURFACE PREPARATION & APPLICATION</b><br/> Separation occurs in glazing Putty; mix entire contents of container until completely uniformed before the application. If necessary, roll into coils to warm and soften.<br/><li>*Surfaces should be clean, dry, and free of frost. When re-glazing, remove all old putty and bedding.<br/></li><li>*Wood sash that is not primed or painted must be primed first with an oil-based primer and allowed to dry. When re-glazing, remove all old putty and bedding. <br/></li><li>* Apply a thin layer of DAP? ?33?? Glazing (about 1/8" thick) to backstop of sash to provide back-bedding where glass is to be set.<br/></li><li>* For metal sash, use spacer shims at quarter points to maintain 1/8" minimum bedding thickness. There should be no metal or wood to glass contact.<br/></li><li>*Smooth glazing to an angle that sheets water with a putty knife. <br/></li><li>*Typical dry time before painting is one to two weeks, depending on temperature and humidity. <br/></li><li>*Putty must be painted after it has skinned over and attained a firm set. Typical dry time before painting is one to two weeks, depending on temperature and humidity. <br/></li><li>*For best results, use a high quality oil-based paint, or if using a latex paint, prime first with a high quality oil-based primer.<br/><b>Product Warning:</b><br/><b>Important Note:</b><br/></li><li>*Do not thin glazing compound. <br/></li><li>*Do not apply when air or sash temperatures are below 40?F (4?C).<br/></li><li>*Do not use on plastic window panes, insulating glass units with an organic seal, any window pane over 48" (1.22 m) in length, or metal sash with rabbets over 1-1/4" (32 mm) wide. <br/></li><li>*Also not recommended for stained/leaded glass projects. <br/></li><li>*Clean tools immediately after use with mineral spirits.<br/><p>.</p></li>