Dixon Valve 2801008C

<p><strong>Dixon, 2801008C, 5/8in ID, 1/2in FNPSM Swivel x Push-On HB, Gasket Seat, Brass </strong> </p> <p><strong>Construction </strong> </p> <ul><li>Gasket seat type </li> </ul> <p><strong>Installation </strong> </p> <ul><li>Assembly Instructions: </li> <li>1. Trim hose end with smooth square cut. </li> <li>2. Lubricate either push-on fitting, hose or both. </li> <li>3. Insert push-on fitting into hose until first barb is in hose. </li> <li>4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap. </li> </ul> <p><strong>Instructions </strong> </p> <ul><li>Disassembly instructions: </li> <li>1. Leaving push-on fitting in place, make a 1" cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose. </li> <li>2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose. </li> </ul> <p><strong>Note </strong> </p> <ul><li>No hose clamps or ferrules are needed </li> </ul> <p><strong>Safety notes </strong> </p> <ul><li>Dixon push-on fittings are intended for use with Lok-On (push-on style) hose only. </li> <li>Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap. </li> <li>WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm. Do not use in connection with drinking water. Wash hands after handling. </li> </ul>