Dixon Valve 48F-12-12

<p><strong>Use </strong> </p> <ul><li>Manufactured especially for hard-to-hold liquids and gases </li> <li>Use with copper, brass, aluminum and welded steel hydraulic tubing that can be flared </li> </ul> <p><strong>Specifications </strong> </p> <ul><li>Listed with Underwriter's Laboratories for flammable liquid, marine, refrigeration and gas applications. Meets functional requirements of SAE J512 and J513, ASA and MS (Military Standards). </li> <li>Reference SAE 010102 </li> </ul> <p><strong>Features </strong> </p> <ul><li>Economical fitting resists mechanical pullout </li> <li>Easy to disassemble and may be reassembled repeatedly, for a leak-proof connection </li> </ul> <p><strong>Construction </strong> </p> <ul><li>Manufactured from CA 360, CA 345 or CA377 brass </li> </ul> <p><strong>Installation </strong> </p> <ul><li>Cut tubing squarely and clean tube end thoroughly to remove burrs. </li> <li>Place nut onto tube. Place threaded end of nut toward end of tube. </li> <li>Flare tube end with flaring tool to provide 45? flare. </li> <li>Clamp tube flare between nut and nose of fitting body by screwing nut on finger-tight. Tighten with a wrench an additional 1/4 turn for metal-to-metal seal. </li> </ul> <p><strong>Safety notes </strong> </p> <ul><li>The PSI rating given is based on a temperature of 73?F using copper tubing. </li> <li>Temperature and type of tubing used are important factors in working pressure ranges. </li> <li>WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm. Do not use in connection with drinking water. Wash hands after handling. </li> </ul>