Dixon Valve 6-DCAP

<p><strong>Applications </strong> </p> <ul><li>Applications include: high pressure, high temperature, nitrogen, helium, flammable gases, hydraulic gases and corrosive media. </li> </ul> <p><strong>Features </strong> </p> <ul><li>Double collet (ferrule) swaging action </li> <li>Two positive seal points </li> </ul> <p><strong>Construction </strong> </p> <ul><li>ASTM material construction </li> <li>316 stainless steel </li> </ul> <p><strong>Compatibility & Interchange Data </strong> </p> <ul><li>Fully interchangeable with Swagelok? and Parker A-Lok? fittings </li> </ul> <p><strong>Installation </strong> </p> <ul><li>Cut tubing squarely and clean tube end thoroughly to remove burrs. </li> <li>Insert tubing into the assembly making sure the tubing seats firm against the shoulder of the body and the nut is finger tight. </li> <li>Tighten the nut with a wrench 1-1/4 turns, while holding the body with a second wrench. </li> </ul> <p><strong>Note </strong> </p> <ul><li>Instrumentation fittings come completely assembled. </li> </ul> <p><strong>Safety notes </strong> </p> <ul><li>Never connect, disconnect or remake a fitting with pressure in the system. </li> <li>Make sure all fittings are properly installed. </li> <li>It is not recommended to go beyond the pressure rating of the tubing. Elongation could occur in the tubing, shrinking the wall thickness and cause potential harm. </li> <li>For proper sealing it is recommended that the tubing and fittings be of like material. </li> <li>Always use proper thread lubricant and sealants on tapered pipe threads. </li> <li>Never bleed a system by loosening a fitting. </li> </ul>