| Advantage | A flexible solution that allows customers to create enclosure configurations made up of smaller individual enclosures. The space required immediately in front of the enclosure is reduced due to the width of each enclosure door being half that of the enclosure. This also results in the door's loading capacity being higher, as it is split over two doors. The installed components inside the enclosure will be safe and secure due to the high protection degree. |
| Benefit | Large enclosure configurations can be created and installed in areas where there is limited access space. The enclosure's doors can support heavy loads, such as, cooling units, due to its increased loading capability. This would provide space for the enclosure doors to support heavier components or equipment such as a cooling unit. Component failure and unnecessary downtime is avoided as water and dust are prevented from entering the enclosure. |
| Bottom plates | Consists of three or four (D>600) pieces. |
| Comment | Mild steel side panels, SPM, need to be ordered separately, to close individual enclosures and enclosure assembly's, to ensure the stated protection degree is achieved. |
| Delivery | Frame with fitted doors, rear panel, roof panel, bottom plates, mounting plate and door frame (not included for PER5 version). For enclosures 2200 mm height, delivery includes two CMB profiles mounted in depth. Delivery also includes earthing bolts. Delivered on a pallet which is identical to the width of the enclosure to allow baying without removal. Packing material is recyclable. |
| Doors | Mounted with four hinges. Including door frame with 25 mm hole pattern. Doors cannot be reversed. Separate doors to be ordered for left hand door locking. |
| Earthing | All panels are earthed through their fittings and equipped with a separate earthing stud. |
| Feature | Mild steel double door combinable floor standing enclosure, with a IP 55 protection degree. |
| Finish | RAL 7035 structured powder coating. |
| Frame | Seam welded reversed open profiles with 25 mm hole pattern, according to DIN 43660. Including integrated external hole pattern. |
| Lock | Espagnolette 4-point locking system in the main door and 2-point locking system in the slave door. Standard double-bit lock with 3 mm insert. Standard inserts, cylinders, lift handles and T-handles are available as accessories. |
| Material | Frame: 1.5 mm painted steel. Doors: 2 mm painted steel. Rear, roof and side panels: 1.5 mm painted steel. Mounting plate: 3 mm galvanized steel. Bottom plates: 1 mm galvanized steel. |
| Mounting plate | Double folded and slides into position. Adjustable in depth by steps of 25 mm, with the MPD02 accessory. Supplied, attached on the outside of the enclosure packaging. |
| Mounting requirements | Standard delivery ready for combined installation. For stand-alone installation add side panels. |
| Protection | Complies with IP55 TYPE 12, 13 IK 10. |
| Rear panel | Fitted by M6 torx screws. Standard facilities for rear doors mounting. Split rear panels in 1600 mm wide enclosures. |
| Roof panel | Removable. |
| Side panels | Supplied as an accessory. |