Headlight Revolution H670

Dead Ballast: If you've got a ballast out on your Nissan, Infiniti, Acura, or Honda; buying a new OEM replacement certainly is not cheap! Custom Setup: If you're doing a quad retrofit on a vehicle with factory HID headlights, these will allow you to run a splitter and relay harness off the factory ballast wiring without any splicing. No Matter What: We're asking ourselves why we didn't make these sooner! These convenient adapters allow the use of aftermarket parts in place of expensive Original-Equipment ballasts with zero cutting, splicing, or re-wiring involved. Quality: Made with stranded copper wire, fully sealed male and female connections, and protected with tech-flex mesh in between; these adapters should last longer than your original ballasts did! Compatibility: Available to fit the OE-side connector on most modern Nissan, Infiniti's, Acura's, and Hondas that use Panasonic/Matsushita Gen III or IV ballasts, or Mitsubishi Electric Gen II or III Ballasts.<br><br><strong>Feature:</strong><ul><li>Wire Thickness: 14 Awg</li><li>Length: Approx. 6In / 150Mm</li><li>Insulation: Braided Techflex</li><li>Connector 1: Oe Matsushita Male</li><li>Connector 2: 9006 Female</li><li>Wiring Adapter: 1x Matsushita Male to 9006 Female Adapter</li><li>Warranty: 2 Years</li><li>Input Type: Oe Matsushita Male (Same As Matsushita Ballast Input)</li><li>Output Type: 9006 Female</li></ul><br>