Architecture | 32-bits |
BOEn | Brown Out Enable (active low). Must be connected to either Vdd or Vss.? If low, RESn becomes a weak output (~5 K?) for monitoring purposes but can be driven low to cause reset. If high, RESn is a CMOS input with Schmitt Trigger. |
Clock Modes | (a) Internal ?20 kHz or ?12 MHz (b) External crystal 4-8 MHz (x 16 PLL) (c) Direct drive |
Cog RAM | 512 x 32 bits each |
Communication | Serial/USB for programming |
Current requirements | ? 9 mA per cog @ 3.3 V, 80 MHz |
Dimensions | 0.35 x 0.35 x 0.05 in (9 x 9 x 1.4 mm) |
Global RAM/ROM | 64 Kbytes; 32 K RAM / 32 K ROM |
I/O Pins | 32 (simultaneously addressable by all eight cogs) |
Operating temp range | -67 to +257 ?F (-55 to +125 ?C) |
P0-P31 | General purpose I/O.? Can source/sink 40 mA each at 3.3 VDC |
P28 | I2C SCL connection to external EEPROM (general purpose I/O after boot up) |
P29 | I2C SDA connection to external EEPROM (general purpose I/O after boot up) |
P30 | Tx to host (general purpose I/O after boot up/download) |
P31 | Rx from host (general purpose I/O after boot up) |
Processors (cogs) | Eight |
RESn | Reset (active low). When low, resets the Propeller chip; all cogs disabled and I/O pins floating. Propeller restarts 50 ms after RESn transitions from low to high. |
System Clock Speed | DC to 80 MHz |
Vdd | Power (3.3 VDC) |
Voltage requirements | 2.7 to 3.3 VDC |
Vss | Ground (0 VDC) |
XI | Crystal / clock input. Can connect to crystal or oscillator |
XO | Crystal Output. Provides feedback for an external crystal. Internal C and R selectable for crystals (no other components required) |