| Angular Misalignment | 2.0? |
| Axial Motion | 0.016 in, 0.40 mm |
| B1 Shaft Penetration, B2 Shaft Penetration | 0.842 in, 21.4 mm |
| Bore Tolerance | +.001 in / -.000 , +.03 mm / -.00 mm |
| Country of Origin | USA |
| Dynamic Torque Non-Reversing | 50 lb-in, 5.65 Nm |
| Dynamic Torque Reversing | 25 lb-in, 2.83 Nm |
| Finish Specification | Sulfuric Anodized MIL-A-8625 Type II, Class 2 and ASTM B580 Type B Black Anodize |
| Forged Clamp Screw | M3 |
| Hex Wrench Size | 2.5 mm |
| Hub Width LH | 0.590 in, 15.0 mm |
| Keyway K1 | 5 mm |
| Keyway K2 | NK |
| Large Bore B1 | 15 mm |
| Length L | 1.770 in / 45.0 mm |
| Manufacturer | Ruland Manufacturing |
| Material Specification | Hubs and Center Spacer: 2024-T351 Aluminum Bar |
| Maximum Speed | 10,000 RPM |
| Note 1 | Stainless steel hubs are available upon request. |
| Note 2 | Torque ratings are at maximum misalignment. |
| Note 3 | Performance ratings are for guidance only. The user must determine suitability for a particular application. |
| Note 4 | Torque ratings for the couplings are based on the physical limitations/failure point of the disc springs. Under normal/typical conditions the hubs are capable of holding up to the rated torque of the disc springs. In some cases, especially when the smallest standard bores are used or where shafts are undersized, slippage on the shaft is possible below the rated torque of the disc springs. Keyways are available to provide additional torque capacity in the shaft/hub connection when required. Please consult technical support for more assistance. |
| Number of Screws | 2 ea |
| Outer Diameter OD | 1.313 in, 33.3 mm |
| Parallel Misalignment | 0.008 in, 0.20 mm |
| Screw Finish | Black Oxide |
| Screw Material | Alloy Steel |
| Seating Torque | 2.1 Nm |
| Small Bore B2 | 0.313 in |
| Static Torque | 100 lb-in, 11.3 Nm |
| Temperature | -10?F to 200?F |
| Torsional Stiffness | 253 lb-in/Deg, 28.6 Nm/Deg |
| UPC | 63452917410 |
| Weight (lbs.) | 0.1650 |