| Angular Misalignment | 1.5? |
| Axial Motion | 0.008 in, 0.20 mm |
| B1 Shaft Penetration, B2 Shaft Penetration | 0.517 in, 13.1 mm |
| Bore Tolerance | +.001 in / -.000 , +.03 mm / -.00 mm |
| Country of Origin | USA |
| Dynamic Torque Non-Reversing | 11 lb-in, 1.25 Nm |
| Dynamic Torque Reversing | 5.5 lb-in, 0.63 Nm |
| Finish Specification | Sulfuric Anodized MIL-A-8625 Type II, Class 2 and ASTM B580 Type B Black Anodize |
| Forged Set Screw | M3 |
| Hex Wrench Size | 1.5 mm |
| Hub Width LH | 0.340 in, 8.65 mm |
| Large Bore B1 | 0.250 in |
| Length L | 1.072 in / 27.2 mm |
| Manufacturer | Ruland Manufacturing |
| Material Specification | Hubs: 2024-T351 Aluminum Bar |
| Maximum Speed | 10,000 RPM |
| Note 1 | Stainless steel hubs are available upon request. |
| Note 2 | Torque ratings are at maximum misalignment. |
| Note 3 | Performance ratings are for guidance only. The user must determine suitability for a particular application. |
| Note 4 | Torque ratings for the couplings are based on the physical limitations/failure point of the metal bellows. Under normal/typical conditions the hubs are capable of holding up to the rated torque of the metal bellows. In some cases, especially when the smallest standard bores are used or where shafts are undersized, slippage on the shaft is possible below the rated torque of the metal bellows. Keyways are available to provide additional torque capacity in the shaft/hub connection when required. Please consult technical support for more assistance. |
| Number of Screws | 2 ea |
| Outer Diameter OD | 0.590 in, 15.0 mm |
| Parallel Misalignment | 0.004 in, 0.10 mm |
| Screw Finish | Black Oxide |
| Screw Material | Alloy Steel |
| Seating Torque | 0.92 Nm |
| Small Bore B2 | 4 mm |
| Static Torque | 22 lb-in, 2.5 Nm |
| Temperature | -40?F to 200?F |
| Torsional Stiffness | 72 lb-in/Deg, 8 Nm/Deg |
| UPC | 63452914260 |
| Weight (lbs.) | 0.0170 |