Simpson 3.5,120V,200Vrms,1R - H335154010

Simpson H335154010 Hawk 3 Digital Panel Meter/Controller 3.5,120V,200VRMS,1R All parameters set from easy to understand front panel access One, two or four 5-amp relays optional Five user-selectable brightness levels 1/8 DIN, shallow depth case, (only 3.24 behind panel) 4-20mA or 0-10 DCV analog retransmission optionalThe Simpson Electric Hawk 3 Advanced Digital Panel Meter/Controller has both 3-1/2 and 4-1/2 digit displays. All LEDs are 7 segment and offer 5 brightness levels.This high quality instrument has user-programmable parameters, all set from the front panel in easy to understand terminology. The display shows activated set point indicators (up to four). The keypad buttons have both audible and tactile feedback to prevent keystroke errors.Mounting RequirementsThe Hawk 3 Advanced Digital Controller 1/8 DIN meters require a panel cutout of 1.77 (45mm) high by 3.62 (92mm) wide.To install the Hawk 3 meter into a panel cutout, remove the clips from the side of the meter.Slide the meter through the panel cutout, then slide the mounting clips back on the meter. Press evenly to ensure a proper fit. Tighten screws.Engineering Label PlacementTo replace the engineering unit label, place the tip of a ballpoint pen into the small hole at the base of the engineering label in the bezel.Slide the label up until it pops out. Grasp and remove. Slide the new label half the distance in, then use the ballpoint pen to slide it down into place.