Whoops, we couldn't find that.

Technical Specification Item Stainless Steel Shaft Shaft Dia. 1.25 Dia. Tolerance Min. 1.2497 Dia. Tolerance Max. 1.249 Mounting End Dia. (In.) 1.25 Thread Size 1/2-13 Thread Length (In.) 1 Length 24 Travel Length (In.) 24 Temp. Range (F) 284 F Material Stainless Steel Min. Surface Hardness 56 HRC This listing is for each. Dimension Y : - Type : - Overall Height (In.) : - Mounting End Dia. (In.) : 1.25 in Dimension C : - Thread Length (In.) : 1 in Dia. Tolerance Min. : 1.2497 in Shaft Dia. : 1.25 in Mounting Holes : - Thread Length (mm) : - Includes : - Temp. Range (F) : 284 F Travel Length (In.) : 24 in Dimension B : 1 in Material : Stainless Steel Base Width (mm) : - Thread Size : 1/2-13 Mounting Hole from Shaft End : - Mounting Hole Size : - Dimension L : 24.0 Mounting Hole Center to Center : - Dimension F : - Dia. Tolerance Max. : 1.249 in Travel Length (mm) : - Agency Compliance : - Min. Surface Hardness : 56 HRC Mounting Surface to Shaft Center (In.) : - Base Height (mm) : - Bolt Size : - Item : Stainless Steel Shaft Dimension P : - Dimension M : 1/2-13 Dimension X : - For Use With : - Dimension G : - Overall Height (mm) : - Length : 24 in Dimension E : - Base Height (In.) : - Finish : - Mounting End Dia. (mm) : - Running Clearance (In/mm) : Rail Width (mm) : Dimension W1 : Dynamic Load Capacity (Lb.) : Dimension W2 : Dimension N : Dimension W4 : Dimension H4 : Dimension L1 : Carriage Length : Mounting Hole to End (In/mm) : Rail Height : Dynamic Load Capacity (N) : Max. Speed (In/Sec) : Dimension H1 : Carriage Hole Size (In.) : Mounting Hole Center to Center (In/mm) : Max. Pv : Base Width : Dimension D3 : Seals : Rail Finish : Dimension W3 : Dimension L3 : Cnt Mtg Hole to Qualify Edge (In/mm) : Max. Speed (m/Sec) : Dimension H : Rail Length : Carriage Height : Static Load Capacity (N) : Dimension W : Liner : Carriage Width : Dimension L2 : Carriage Material : Carriage Type : Hole Size : Rail Material : Base Width (In.) : Number of Rail Holes :