Order 2960404SS by Dixon Valve 1/4" Hose ID, 303 SS, Push-On Hose Mender - US Mega Store

<p><strong>1/4&quot; Hose ID, 303 SS, Push-On Hose Mender</strong></p><p><strong>Specifications:</strong></p><ul><li>Number of Barbs: 2</li><li>Barb Length: .77&quot;</li></ul><p><strong>Installation:</strong></p><ul><li>Assembly Instructions:</li><li>1. Trim hose end with smooth square cut.</li><li>2. Lubricate either push-on fitting, hose or both.</li><li>3. Insert push-on fitting into hose until first barb is in hose.</li><li>4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap.</li></ul><p><strong>Instructions:</strong></p><ul><li>Disassembly instructions:</li><li>1. Leaving push-on fitting in place, make a 1&quot; cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.</li><li>2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose.</li></ul><p><strong>Note:</strong></p><ul><li>No hose clamps or ferrules are needed</li></ul><p><strong>Safety notes:</strong></p><ul><li>Dixon push-on fittings are intended for use with Lok-On (push-on style) hose only.</li><li>Lok-On fittings will properly grip Lok-On hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.</li><li>WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm. Do not use in connection with drinking water. Wash hands after handling.</li></ul>