110990445 Seeed Technology Co., Ltd | Development Boards, Kits, Programmers | DigiKey

Bus Blaster V3c for MIPS is an economical, yet high-speed debug adapter designed for supporting JTAG debug with various MIPS processors. This version of the Bus Blaster has a 14-pin target connector and interface cable with buffering logic suitable for MIPS EJTAG targets. In other respects it is the same as the standard Bus Blaster V3c<br /><br /><b> Features: </b><br /><br /> - Designed?for?MIPS?(EJTAG)?targets?with?14?pin?connector<br />- Includes?100?cm?USB?host?cable<br />- Includes?20?cm?target?cable?with?14?pin?IDC?connectors?on?each?end<br />- Includes?Bus?Blaster?acrylic?case?panels?and?nylon?screws?(assembly?required)<br />- Based?on?FT2232H?chip?with?high-speed?USB?2.0<br />- Buffered?interface?works?with?3.3?volt?to?1.8?volt?targets<br />- Reprogrammable?buffer?is?compatible?with?multiple?debugger?types<br />- Compatible?with?'jtagkey',?'KT-link'?programmer?settings?in?OpenOCD,?urJTAG,?and?more<br />- Ships?with?JTAGkey?compatible?buffer?image?pre-programmed<br />- Mini-CPLD?development?board:?self-programmable,?extra?CPLD?pins?to?header<br />- Open?source?(CC-BY-SA)<br /><br /><b>Specification: </b><br /><br /> - Part?list:<br />- USB?Cable;?Mini?A-1000mm-Black?x1<br />- Bus?Blaster?v3?acrylic?case?v1-MIPS?version?x1<br />- 14?pin?(2x7)?ribbon?cable?with?IDC?connector?on?both?ends?x1<br />- Bus?Blaster?v3c?EJTAG?for?MIPS?x1<br />- Bus?Blaster?Manual<br />- Bus?Blaster?design?overview<br />- CPLD?buffer?logic?overview<br />- Software, hardware and technical support<br />- Open?OCD?resources<br />- This open source hardware and software is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.<br />