Please note:<br> This is not an iRobot Original product and is not covered by any iRobot warranty. <br> iRobot brand names and logos are registered trademarks of their respective owners. <br> Use the iRobot brand name for this product, model or part name is only used to prove compatibility. Suitable model:<br> For iRobot Roomba 800/900 Series 870 880 980<br> How to clean up Extractors:<br> 1. Pinch the yellow extractor frame release tab, lift the extractor frame and remove any obstructions. <br> 2. Remove the extractor and remove the yellow extractor cap. <br> Remove any hair or debris collected under the cap and around the metal shaft. <br> 3. Remove the hair and debris from the square and hexagonal plastic studs on the other side of the extractor. How to clean the side brush:<br> To clean the side brush, use a small corner screwdriver to remove the screw. <br> Then remove the brush, remove the hair or debris, and put the side brush back in place. <br> How to clean the filter:<br> 1. Press the tray release button to remove the paper slot<br> 2. Open the trash can door to empty the trash can<br> 3. Now press and lift the filter or release the tab<br> 4. Grab the yellow label and remove the filter<br> 5. Filter the clean room by tapping the trash can<br> 6. Reinstall the filter, press the metal filter rod, push the filter side and push the filter down, <br> If the filter is not installed correctly, the filter door will not close <br> What is in the box:<br> 2 X Tangle-Free Fragment Extractor<br> 4 replacement side brushes<br> 4 x replacement HEPA filter<br> 4 screws