2920608CBC 3/8" P/O Hose x 1/2"-20 UNF Fem Br Rigid SAE Invert Flare w/brasscap from Dixon Valve & Coupling Co

LOKON SAE INV.FL. FEM 3/8 X1/2-20 W/ BRASS CAP

<p><strong>2920608CBC, 5/16" Tube OD x 3/8" Hose ID Female SAE Inverted Flare Rigid x Hose Barb</p></strong><p><strong>Barb Specifications</strong></p><ul><li>Number of Barbs: 2</li><li>Barb Length:.92"</li></ul><p><strong>Installation</strong></p><ul><li><strong>Assembly Instructions:</strong><ul><li>1. Trim hose end with smooth square cut.</li><li>2. Lubricate either push-on fitting, hose or both.</li><li>3. Insert push-on fitting into hose until first barb is in hose.</li><li>4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap.</li></ul></li></ul><p><strong>Instructions</strong></p><ul><li><strong>Disassembly instructions:</strong><ul><li>1. Leaving push-on fitting in place, make a 1" cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.</li><li>2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose.</li></ul></li></ul><p><strong>Note</strong></p><ul><li>No hose clamps or ferrules are needed</li></ul><p><strong>Safety Notes</strong></p><ul><li>Dixon push-on fittings are intended for use with Lok-On (push-on style) hose only.</li><li>Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.</li></ul>