Dixon Valve 37Deg JIC Swiv x Push-On HB 2880609SS. ✅Dixon Valve authorized distributor ✅. ☎ (800) 884-5767 Mon-Fri 8:00 AM - 5:00 PM ET or order online 24/7

<p><strong>Dixon, 2880609SS, 3/8&quot; x 9/16&quot;-18 UNF Thd, 303SS, Fem 37Deg JIC Swiv x Push-On HB</strong></p><p><strong>Specifications:</strong></p><ul><li>Number of Barbs: 2</li><li>Barb Length: .92&quot;</li></ul><p><strong>Installation:</strong></p><ul><li>Trim hose end with a smooth square cut.</li><li>Lubricate either Lok-On fitting, hose or both.</li><li>Insert Lok-on fitting into hose until first barb is in the hose.</li><li>Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from the end. Push with a steady force until the end of the hose is covered by the yellow plastic cap.</li></ul><p><strong>Note:</strong></p><ul><li>No hose clamps or ferrules are needed</li></ul><p><strong>Instructions:</strong></p><ul><li>Disassembly instructions:</li><li>1. Leaving push-on fitting in place, make a 1&quot; cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.</li><li>2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose.</li></ul><p><strong>Safety notes:</strong></p><ul><li>Dixon push-on fittings are intended for use with Lok-On (push-on style) hose only.</li><li>Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.</li><li>WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm. Do not use in connection with drinking water. Wash hands after handling.</li></ul>