Shaft,Steel,0.500 In D,36.00 In

Technical Specification Item Steel Shaft Shaft Dia. 0.5 Dia. Tolerance Min. 0.4998 Dia. Tolerance Max. 0.4993 Mounting End Dia. (In.) 0.5 Thread Size 1/4-20 Thread Length (In.) 0.5 Length 36 Travel Length (In.) 36 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Mounting End Dia. (mm) : - Mounting Hole from Shaft End : - Dimension Y : - Shaft Dia. : 0.5 in Includes : - Dimension L : 36.0 Dimension P : - Length : 36 in Dia. Tolerance Max. : 0.4993 in Dimension G : - Dimension M : 1/4-20 Mounting End Dia. (In.) : 0.5 in Mounting Holes : - Thread Size : 1/4-20 Bolt Size : - Mounting Hole Size : - Item : Steel Shaft Dimension B : 0.5 in Min. Surface Hardness : 60 HRC Finish : - Temp. Range (F) : 230 F Base Height (In.) : - Mounting Hole Center to Center : - Dimension F : - Overall Height (In.) : - Dimension X : - Dimension E : - Travel Length (mm) : - Mounting Surface to Shaft Center (In.) : - Thread Length (In.) : 0.5 in Overall Height (mm) : - For Use With : - Agency Compliance : - Dimension C : - Base Height (mm) : - Dia. Tolerance Min. : 0.4998 in Material : Steel Type : - Thread Length (mm) : - Travel Length (In.) : 36 in Base Width (mm) : - Dynamic Load Capacity (Lb.) : Base Width : Dimension W3 : Number of Rail Holes : Base Width (In.) : Dimension W2 : Carriage Hole Size (mm) : Carriage Height : Rail Width (mm) : Carriage Type : Dimension N : Dimension L2 : Dimension W : Rail Length : Static Load Capacity (Lb.) : Dimension S X l (Carriage Hole Size) : Carriage Material : Dimension H : Max. Pv : Cnt Mtg Hole to Qualify Edge (In/mm) : Liner : Rail Finish : Max. Speed (m/Sec) : Dimension H1 : Dynamic Load Capacity (N) : Mounting Hole to End (In/mm) : Running Clearance (In/mm) : Dimension H4 : Carriage Width : Carriage Hole Size (In.) : Hole Size : Dimension L3 : Rail Height : Dimension D3 : Carriage Length : Max. Speed (In/Sec) : Dimension L1 : Static Load Capacity (N) : Seals : Dimension D2 : Dimension W4 :