<p></p> <p>This converter include PD signature sensing and power monitoring features per the IEEE 802.3af standard. Other features include Over-Current Protection, Under-Current Detection and Fault Protection Input. The PoE converter is fully compatible with devices that comply with the IEEE802.3af standard. The PoE converter is capable of inserting power on data pairs of the MDI.</p> <p></p> <b><u>Interfaces/Ports</u><br /></b> <br /> <b>Total Number of Ports:</b> 2 <br /> <b>Network (RJ-45):</b> Yes <br /> <b>Number of Network (RJ-45) Ports:</b> 1 <br /> <b>Number of ST Ports:</b> 1 <br /> <br /> <b><u>Media &amp; Performance</u><br /></b> <br /> <b>Media Type Supported:</b> Twisted Pair, Optical Fiber <br /> <b>Fiber Mode Supported:</b> Multi-mode <br /> <b>Maximum Distance Supported:</b> 1.24 Mile <br /> <br /> <b><u>Network &amp; Communication</u><br /></b> <br /> <b>Ethernet Technology:</b> Fast Ethernet <br /> <b>Network Technology:</b> 10/100Base-TX, 100Base-FX <br /> <br /> <b><u>Physical Characteristics</u><br /></b> <br /> <b>Form Factor:</b> Wall Mountable <br /> <b>Height:</b> 1&quot; <br /> <b>Width:</b> 3.3&quot; <br /> <b>Depth:</b> 4.8&quot; <br /> <br /> <b><u>Miscellaneous</u><br /></b> <br /> <b>Additional Information:</b> <ul> <li>48 VDC PSE output voltage</li> <li>SW1: Auto-Negotiation On/Off</li> <li>SW2: Speed TP: Force 10Mbps or 100Mbps (SW1 off)</li> <li>SW3: Duplex TP: Force Half or Full Duplex (SW1 off)</li> <li>SW4: Duplex Fiber: Half or Full Duplex</li> <li>SW5: AutoCross On/Off</li> <li>SW6: PSE On/Off</li> <li>SW7: PSE/LPT on/off</li> <li>SW8: Unused</li> </ul> <br /> <br /> <b><u>Warranty</u><br /></b> <br /> <b>Limited Warranty:</b> Lifetime