Dixon Valve 37Deg JIC Swivel x Push-On Hose Barb 2881217SS. ✅Dixon Valve authorized distributor ✅. ☎ (800) 884-5767 Mon-Fri 8:00 AM - 5:00 PM ET or order online 24/7

<p><strong>Dixon, 2881217SS, 3/4 x 1-1/16-12 UNF Thread, HB F 37Deg JIC Swivel x Push-On Hose Barb 303SS</strong></p><p><strong>Specifications:</strong></p><ul><li>Number of Barbs: 3</li><li>Barb Length: 1.50"</li></ul><p><strong>Installation:</strong></p><ul><li>Assembly Instructions:</li><li>1. Trim hose end with smooth square cut.</li><li>2. Lubricate either push-on fitting, hose or both.</li><li>3. Insert push-on fitting into hose until first barb is in hose.</li><li>4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap.</li></ul><p><strong>Instructions:</strong></p><ul><li>Disassembly instructions:</li><li>1. Leaving push-on fitting in place, make a 1" cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.</li><li>2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose.</li></ul><p><strong>Note:</strong></p><ul><li>No hose clamps or ferrules are needed</li></ul><p><strong>Safety notes:</strong></p><ul><li>Dixon push-on fittings are intended for use with Lok-On (push-on style) hose only.</li><li>Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.</li></ul>