2720806SS - Male NPT x Push-On Hose Barb - Dixon Valve & Coupling

Push-On Hose Fitting, For Hose I.D. 1/2 in, Barb Size 1/2 in, Rigid, Fitting Shape Straight, Hex Head Size 11/16 in, Hose Fitting A Gender Male, Hose Fitting B Gender Male, Hose Fitting A Size 1/2 in, Hose Fitting B Size 3/8 in, Hose Fitting A Connection Type Hose Barb, Hose Fitting B Connection Type NPT, Fitting Material 303 Stainless Steel x 303 Stainless Steel, Reusable Yes, 350 psi

<p><strong>Dixon, 2720806SS, 1/2in Hose ID x 3/8in-18 Male NPT x Push-On Hose Barb, 303SS</strong></p><p><strong>Construction</strong></p><ul><li>Dryseal</li></ul><p><strong>Installation</strong></p><ul><li>Assembly Instructions:</li><li>1. Trim hose end with smooth square cut.</li><li>2. Lubricate either push-on fitting, hose or both.</li><li>3. Insert push-on fitting into hose until first barb is in hose.</li><li>4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap.</li></ul><p><strong>Instructions</strong></p><ul><li>Disassembly instructions:</li><li>1. Leaving push-on fitting in place, make a 1in cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.</li><li>2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose.</li></ul><p><strong>Note</strong></p><ul><li>No hose clamps or ferrules are needed</li></ul><p><strong>Safety notes</strong></p><ul><li>Dixon push-on fittings are intended for use with Lok-On (push-on style) hose only.</li><li>Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.</li><li>WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm. Do not use in connection with drinking water. Wash hands after handling.</li></ul>