Bob's Machine . 100-205100

Bob's Machine Shop's Heavy Duty Manual Jack Plate is actually 4 units in one that can have a straight or negative 6 degree wedge, with a 5? setback. Features: -Anodized black -Simple 4 in 1 Conversion -Adjustable plates turn 180 degrees and switch sides, then bolt in place. -Overall width: 17-7/8 (45.3cm) -Overall height:14 (35.5cm). -2 ½ (6.3cm) of lift built in and 4 (10.1cm) of adjustable lift. -Lifetime warranty on structure -Made in FL, USA -Rated for up to 300 HP or 625lb motors. -Light-weight, 26 lbs, Aircraft grade aluminum and stainless steel.. -Narrow design -Fits V6 -Pre-drilled to fit all late model V6's. -Can be modified to fit any size outboard Mounting Options: -2 1/2 inch offset no wedge -5-inch Offset with 6-Degree Wedge -2 1/2 inch offset no wedge -2 1/2 inch Offset with Negative 6-Degree Wedge -5-inch Offset No Wedge -5-inch Offset with 6-Degree Wedge Jacking bolts: allow motor to be moved to any height. No need to take boat out of the water. Offset: positions motor 5 1/2 inches behind transom. This allows prop to run in cleaner water, away from the turbulence and bubbles created by the hull. This helps stop slippage of prop, and helps stop torque in steering wheel at high speeds. Trim-In: this allows motor to be trimmed in or down 6 degrees more than if mounted flat on transom. Helps stop low speed porpoising. Balance load better.