Attribute15: Fractional Inch
Products with this attribute (56 total)
Annular Cutter, High Speed Steel, Bright (Uncoated), 2 3/16 in, Weldon Flat, Shank Diameter 3/4 in, Maximum Cutting Depth 4 in
BALL END MILL, 2 FLUTES, 0.875 IN MILLING DIAMETER, 2 IN CUT, 4.25 IN LENGTH, HSS
BIT,DRILL SET, 1/16 - 1/2 IN DIA, 1
Bosch
Carbide Tipped Cutter, 3 Dia, 2 D
Collet, DA100, Round, Overall Length 1.4380 in
Collet, DA180, Round, Overall Length 1-5/8 in
Collet, ER32, Round, Overall Length 40.00mm
Collet, TG100, Round, Overall Length 2-3/8 in
Collet, TG100, Round, Overall Length 2-3/8 in
Collet, TG75, Round, Overall Length 1.8440 in
Collet, TG75, Round, Overall Length 1.8440 in
Collet,DA180,11/32
Diamond Turning Insert, Diamond, 3/8", 80 Degrees, 0.0039"
DRILL GP,HSS,BRIGHT,1/2
DRILL GP,HSS,BRIGHT,19/64
DRILL GP,HSS,BRIGHT,23/64
DRILL GP,HSS,BRIGHT,7/32
DRILL GP,HSS,BRIGHT,9/32
DRILL GP,HSS,TIN,15/32
DRILL GP,HSS,TIN,19/64
DRILL SET,COBALT,TIN,1/16
DRILL TAP SHANK,HSS,STEAM OXIDE,1-3/8
DRILL,HSS,BLACK & GOLD,13/32
DRILLSET COBALT STRAW/GOLDOX 1/16
End Mill Holder, Taper Size BT40, Bore Dia. 7/16 in, Projection 2-1/2 in, Nose Dia. 1.1000 in, Measurement System Fractional Inch, End Type Single End
END MILL, HSS, 1-1/2
END MILL, HSS, 3/8
End Mill, TiCN, 0.7500 in Milling Dia, 6205
END MILLGP, HSS, 5/8
END MILLGP, HSS, 5/8
Erickson
Kyocera
Kyocera
Kyocera
Monster Tool Co
Onsrud
Osg
Osg
Osg
Osg
Osg
Osg
REDUCED SHANK DRILL BIT,
ROUGHER, COBALT, 1
ROUGHER, HSS, 1/8
ROUGHER, HSS, 3/16
Slip-Fixed/Renewable Drill Bushing (SF), Standard Wall, Headed, Fractional Inch, 1 19/64 in
Slip-Fixed/Renewable Drill Bushing (SF), Standard Wall, Headed, Fractional Inch, 1 3/4 in
Slip-Fixed/Renewable Drill Bushing (SF), Standard Wall, Headed, Fractional Inch, 1 3/8 in
SQUARE END MILL, BRIGHT/UNCOATED FINISH, NON-CENTRE CUTTING, 6 FLUTES, 6 IN CUT, COBALT
Sumitomo
TAP SET ,HSS,BRIGHT,7/8-14 UNF
TAPER SHANK DRILL BIT, 63/64 IN DRILL BIT SIZE, 6
Walter Titex
Zoro Select