AttributeKey22: Primary Material Application ISO Code

Products with this attribute (63 total)

Carbide End Mill,1/2In,2FL,Single,6In

Carbide End Mill,25.0mm,4FL,Single

Carbide End Mill,3.0mm,4FL,Single

Carbide End Mill,3/16In,2FL,Single,2In

Carbide End Mill,5.0mm,4FL,Single

Carbide End Mill,7/64In,2FL,Single,1-1/2

Carbide End Mill,9/16In,2FL,Single,3-1/2

Chucking Reamer, Carbide, Bright (Uncoated), Straight, Metric, 8.00 mm

Chucking Reamer, Cobalt, Bright (Uncoated), Straight, Wire, #26

Chucking Reamer, Cobalt, Bright (Uncoated), Straight, Wire, #39

Chucking Reamer, Cobalt, Bright (Uncoated), Straight, Wire, #4

Chucking Reamer,#33,4 Flute,Carbide

Chucking Reamer,#56,4 Flute,Cobalt

Countersink, 100 Degrees , 3/8 in, Cobalt, TiN

Countersink, 120 Degrees , 5/16 in, Carbide, TiAlN

Countersink, 82 Degrees , 1 1/2 in, High Speed Steel, TiN

Countersink,AlTiN,82 deg. Angle,2-1/2" L

Diamond Turning Insert, Diamond, 1/2", 80 Degrees, 1/16"

Diamond Turning Insert, Diamond, 3/8", 35 Degrees, 1/32"

Diamond Turning Insert, Diamond, 3/8", 80 Degrees, 0.0039"

End Mill,1/4 in.2 Flutes,TiN

End Mill,5/8 in.4 Flutes,TiN

Indexable Boring Bar, Insert Shape 80 Degrees Diamond, Overall Length 300.00mm, 95 Degrees , 27.00mm, AP302-CN16 Shim, FS1463 Screw, FS1464 Torx Key, FS1471 Pressure Spring, FS1474 Clamp Screw, PK242 Clamp, RS117 Pin, Coolant Through, Facing, Interrupted Cuts, Profiling, Turning, Right Hand

Indexable Boring Bar, Insert Shape Trigon, Overall Length 12 in, A16T-SWLCL3, 95 Degrees , 41/64 in, FS1465 Torx key, FS2062 Clamping Screw, Coolant Through, Facing, Interrupted Cuts, Profiling, Turning, Left Hand

Indexable Boring Bar, Insert Shape Trigon, Overall Length 200.00mm, 95 Degrees , 11.00mm, FS1490 Torx Key, FS2067 Clamping Screw, Coolant Through, Facing, Interrupted Cuts, Profiling, Turning, Left Hand

Monster Tool Co

Monster Tool Co

ROCKY MOUNTAIN TWIST, #17 Drill Bit Size, 9/16 in Flute Lg, Threaded Shank Drill Bit - 52NW61|953HS17SS - Grainger

Spiral Point Tap, M24-3, Taper, Metric Coarse, 4 Flutes, Uncoated

SQUARE END MILL, CENTRE CUTTING, 4 FLUTES, 3/16 IN MILLING DIAMETER,

Walter Prototyp