Brand: Indusco Products

All products from this brand (2 total)

Indusco clips are intended for use in making eye termination in right regular lay wire rope. The efficiency rating of a properly prepared termination for clips is 80 percent, this rating is based on the catalog breaking strength of the wire rope. If pulley is used in turnback instead of thimble or if Seale construction or similar large outer wire type construction in 6 x 19 class is used in 1-inches and up, add additional clip. Minimum number of clips per eye: 3. Amount of rope to turn back: 11-1/2-inches. 1/2-inches trade size. Meets Design Requirements According to Federal Specification FFC 450D, Type 1, Class 1.

Indusco self-colored high test grade 40 steel clevis slip hook. Not for overhead lifting. Failure to follow the instructions for use below and these warnings may cause death or serious injury. Never lift with the tip of the hook. Never point load a hook. Do not use hooks for lifting personnel. Hooks must always be inspected for wear, distortion and damage before use. If worn, distorted or damaged, discard and replace. Always stand clear of loads being lifted. 5/8-inches chain size. 9250 pounds working load limit. Working load limit is based on a design factor of 4:1.