Buy NUX NMP-2, Dual Footswitch Controller - Prime Buy

<b>1, Foot Switch A</b><br>Use this as a switch for the device connected to Jack A or Jack B&A. Refer to "Connections". <br> <b>2, Foot Switch B</b><br>Use this as a switch for the device connected to Jack B or Jack B&A. Refer to "Connections". <br> <b>3, Foot Switch A Indicator </b> <br>When foot switch A is set to the latch type function, this indicator alternately lights or goes out each time the foot switch is pressed. When foot switch A is set to the momentary type function(open or close), thisindicator lights only while the foot switch is held down.<br><b>4, Foot Switch B Indicator</b><br>When foot switch B is set to the latch type function, this indicator alternately lights or goes out each time the foot switch is pressed. When foot switch B is set to the momentary type function(open or close), this indicator lights only while the foot switch is held down.<br><b>5, DC Jack</b><br>The NMP-2 uses 9V (Positive outside, Negative inside) 2.5mm plug to active Latch mode, open mode(also close mode with indicator).<br><b>6, Jack A</b><br>Connect the device being controlled with foot switch A here. Use a connection cable with 1/4” (6.35mm) phone plugs at both ends.<br><b>7, Jack B&A</b><br>Connect devices equipped with TRS or TS 1/4” (6.35mm) phone jacks here. Use a connection cable with stereo or mono 1/4” (6.35mm) phone plugs at both ends.<br> *TS(mono) is for foot switch B only. If you want to operate foot switch A and foot switch B at the same time, you must use TRS(stereo) phone plugs here. <br><b>8, Mode Switch</b><br>This sets the functions for foot switch A and B to LATCH or Momentary( Open , Close).<br> *After referring the owner’s manual for the device you are connecting, switch this to the appropriate setting.<br> Open mode means while you hold the foot switch, the Tip and Sleeve is opened.(using mono cable)<br>Close mode means while you hold the foot switch, the Tip and Sleeve is closed.(using mono cable)