High Pressure FRL Regulator,3/8 In. NPT

The Milton heavy duty RELIEVING TYPE regulators offer stable downstream air pressure over a wide range of air flows with accurate control, fast response and minimal pressure drop. Offset 1/4” gage ports can also serve as two 1/4” supply lines, allowing up to three regulated full flow out ports. Gage not included, but available as an accessory.  Inlet pressure: 250 PSI Operating temperature: 40° F to 120° F Aluminum die-cast body Buna-N diaphragm and O rings Balanced piston, molded rubber seat 3/8" NPT Size 80 Max SCFM 10-250 PSI Warning: Regulators should always be preceded by a filter to eliminate damage to the unit or inaccurate air flow.

3/8" NPT high pressure regulator is the heavy duty relieving type and offers a stable downstream air pressure over a wide range of air flows with accurate control, fast response time and minimal pressure drop. Offset gage ports can also serve as two 1/4" supply lines. The aluminum die cast body comes with a balanced piston and molded rubber seat. Mas a Maximum inlet pressure of 250 PSI and offers up to 80 SCFM. 3/8" national pipe thread Maximum of 80 standard cubic feet per minute at 100 pounds per square inch Operating temperature range of 40 degrees Fahrenheit to 120 degrees Fahrenheit