Motobilt Jeep JK Front Bumper W/Stinger 07-18 Wrangler JK Crusher Series Bare Steel - MB1011-S

The Motobilt Crusher recessed winch bumper with stinger will provide you the ultimate in protection and recovery. It will fit the Wrangler JK. The bumper allows you to secure your winch down low in between the frame rails. The stinger bar is made out of 1.75 inch x .120 inch wall DOM tube and is braced with laser cut gussets. The high clearance design includes a built in skid plate also. The bumper is made from 3/16 inch thick steel plate that is laser cut at Motobilt HQ then cnc bent. The bumper uses 3/4 inch thick laser cut d-ring mounts that pass through the bumper and are welded both inside and out. This setup provides for superior strength. Features: Wrangler JK front Crusher recessed winch bumper with stinger Measures in at just 46.5 inch at its widest point 3/16 inch thick steel plate 3/4 inch thick laser cut d-ring mounts that pass through the bumper and our welded both inside and out The stinger bar is made out of 1.75 inch x .120 inch wall DOM tube and braced with laser cut gussets Includes all the necessary mounting hardware Sold as each Note: Will Not work with Teraflex S/T Dual rate front sway bar The outer edge of the crash bar will need to be trimmed to fit where the lower portion of the bumper mounts Ships bare steel and will need to be painted or powdercoated once you receive it 2012 and newer models will need a vacuum relocation pump PN MB2060 Fairlead spacer included to allow use of a centered or off set winch design. Does NOT work with Super Winch EXP