Motobilt Jeep TJ Competition Cut Corners Bare Steel Pair - MB1051

Finally using specially made tooling they are cnc formed to precise tolerances. These process in design and fabrication allows for a great fit on your vehicle. Every aspect of production from design, fabrication, to shipping is all done in house at Motobilt. This allows us to ensure the best in American made quality. The competition cut allows you to run much larger tires and gives room to stretch your wheel base. These corners are perfect with our back half kit. It is also designed to fit TJ. You can really move the rear axle back to get the wheel base you need and provide a great departure angle for those really big rocks! When installing these corner guards you will need to cut much of the factory sheet metal away including the boxed in portion on the interior of your stock corners. Usually this requires the factory body mount to be removed also. A good way to reinforce this area is to tie the roll cage into the rear section of the frame. The corners have a 4.5 inch hole laser cut in back for a flush mount led taillight. All of the mounting locations are countersunk to keep the side of your clean and slick. Flush mount hardware is included. Most of the hardware uses a through hole with a nyloc nut on the back side. There are a few locations where the back side cannot be accessed so a nut sert is provided and will be used in these locations. These corners are designed to work with the Motobilt rocker guards MB1054 and MB1054s. They work perfectly together to keep your vehicle's body completely protected.