Grainger.com

Technical Specification Item Steel Shaft Shaft Dia. 0.75 Dia. Tolerance Min. 0.7497 Dia. Tolerance Max. 0.7492 Mounting End Dia. (In.) 0.75 Thread Size 5/16-18 Thread Length (In.) 0.625 Length 24 Travel Length (In.) 24 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Item : Steel Shaft Dimension X : - Dimension Y : - Length : 24 in Overall Height (In.) : - Temp. Range (F) : 230 F Material : Steel Base Height (In.) : - Finish : - Mounting End Dia. (mm) : - Dimension P : - Dimension M : 5/16-18 Agency Compliance : - Dimension C : - Shaft Dia. : 0.75 in Dia. Tolerance Max. : 0.7492 in For Use With : - Travel Length (mm) : - Mounting Hole from Shaft End : - Mounting Holes : - Dimension L : 24.0 Thread Length (mm) : - Dia. Tolerance Min. : 0.7497 in Travel Length (In.) : 24 in Bolt Size : - Thread Length (In.) : 0.625 in Mounting Hole Size : - Base Width (mm) : - Dimension F : - Thread Size : 5/16-18 Dimension G : - Overall Height (mm) : - Includes : - Dimension E : - Base Height (mm) : - Type : - Mounting End Dia. (In.) : 0.75 in Dimension B : 0.625 in Min. Surface Hardness : 60 HRC Mounting Hole Center to Center : - Mounting Surface to Shaft Center (In.) : - Rail Material : Dimension D3 : Dimension S X l (Carriage Hole Size) : Static Load Capacity (Lb.) : Dimension L1 : Dimension W1 : Carriage Hole Size (In.) : Carriage Type : Base Width : Dynamic Load Capacity (Lb.) : Dimension D2 : Mounting Hole Center to Center (In/mm) : Max. Speed (In/Sec) : Base Width (In.) : Seals : Cnt Mtg Hole to Qualify Edge (In/mm) : Mounting Hole to End (In/mm) : Carriage Length : Dimension W4 : Rail Height : Running Clearance (In/mm) : Rail Finish : Max. Speed (m/Sec) : Carriage Hole Size (mm) : Carriage Height : Dimension H4 : Carriage Width : Dimension W2 : Dimension W3 : Max. Pv : Dimension N : Dynamic Load Capacity (N) : Dimension L3 : Rail Width (mm) : Carriage Material : Dimension W : Number of Rail Holes : Rail Length :