Whoops, we couldn't find that.

Technical Specification Item Steel Shaft Shaft Dia. 0.5 Dia. Tolerance Min. 0.4998 Dia. Tolerance Max. 0.4993 Mounting End Dia. (In.) 0.5 Thread Size 1/4-20 Thread Length (In.) 0.5 Length 6 Travel Length (In.) 6 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Finish : - Dia. Tolerance Max. : 0.4993 in Dimension F : - Mounting End Dia. (In.) : 0.5 in Mounting Hole from Shaft End : - Thread Length (mm) : - Dimension L : 6.0 Base Height (mm) : - Dimension E : - Length : 6 in Travel Length (mm) : - Overall Height (In.) : - Mounting Hole Center to Center : - Travel Length (In.) : 6 in Dimension C : - Mounting End Dia. (mm) : - Dimension P : - Dia. Tolerance Min. : 0.4998 in Base Height (In.) : - Base Width (mm) : - Material : Steel For Use With : - Dimension G : - Bolt Size : - Item : Steel Shaft Dimension B : 0.5 in Shaft Dia. : 0.5 in Dimension M : 1/4-20 Mounting Surface to Shaft Center (In.) : - Dimension X : - Overall Height (mm) : - Mounting Holes : - Agency Compliance : - Type : - Thread Length (In.) : 0.5 in Includes : - Min. Surface Hardness : 60 HRC Temp. Range (F) : 230 F Thread Size : 1/4-20 Mounting Hole Size : - Dimension Y : - Mounting Hole Center to Center (In/mm) : Dimension W3 : Carriage Width : Static Load Capacity (N) : Dimension D3 : Max. Speed (In/Sec) : Max. Pv : Carriage Length : Rail Material : Dimension N : Running Clearance (In/mm) : Carriage Height : Mounting Hole to End (In/mm) : Dimension S X l (Carriage Hole Size) : Rail Finish : Dimension W2 : Dimension H : Dimension H1 : Rail Width (mm) : Dimension L2 : Liner : Carriage Hole Size (In.) : Hole Size : Cnt Mtg Hole to Qualify Edge (In/mm) : Base Width : Carriage Hole Size (mm) : Dimension L3 : Dimension L1 : Carriage Material : Carriage Type : Dynamic Load Capacity (N) : Rail Height : Static Load Capacity (Lb.) : Dimension W4 : Number of Rail Holes : Dimension H4 : Base Width (In.) : Seals : Rail Length : Max. Speed (m/Sec) : Dimension