Whoops, we couldn't find that.

Technical Specification Item Steel Shaft Shaft Dia. 0.75 Dia. Tolerance Min. 0.7497 Dia. Tolerance Max. 0.7492 Mounting End Dia. (In.) 0.75 Thread Size 5/16-18 Thread Length (In.) 0.625 Length 24 Travel Length (In.) 24 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Mounting Surface to Shaft Center (In.) : - Overall Height (mm) : - Dimension L : 24.0 Mounting End Dia. (In.) : 0.75 in Dimension E : - Agency Compliance : - Dimension C : - Length : 24 in Min. Surface Hardness : 60 HRC Mounting End Dia. (mm) : - Mounting Hole from Shaft End : - Mounting Hole Size : - Shaft Dia. : 0.75 in Includes : - Dimension Y : - Mounting Holes : - Dia. Tolerance Min. : 0.7497 in Dimension P : - Dimension F : - Base Height (In.) : - Base Height (mm) : - Overall Height (In.) : - Base Width (mm) : - Thread Length (mm) : - Type : - Temp. Range (F) : 230 F Material : Steel Dimension B : 0.625 in Item : Steel Shaft Travel Length (mm) : - Dimension G : - For Use With : - Travel Length (In.) : 24 in Dimension X : - Finish : - Thread Size : 5/16-18 Bolt Size : - Mounting Hole Center to Center : - Dimension M : 5/16-18 Thread Length (In.) : 0.625 in Dia. Tolerance Max. : 0.7492 in Dimension L2 : Dimension W3 : Dimension L3 : Running Clearance (In/mm) : Dimension L1 : Dimension H1 : Dimension D3 : Dimension S X l (Carriage Hole Size) : Static Load Capacity (N) : Rail Finish : Dimension W2 : Dynamic Load Capacity (Lb.) : Dimension W1 : Carriage Length : Rail Material : Carriage Height : Dimension H4 : Carriage Material : Dimension H : Dimension D2 : Rail Height : Rail Width (mm) : Mounting Hole Center to Center (In/mm) : Hole Size : Liner : Cnt Mtg Hole to Qualify Edge (In/mm) : Rail Length : Dynamic Load Capacity (N) : Carriage Type : Number of Rail Holes : Dimension W4 : Carriage Hole Size (mm) : Max. Speed (m/Sec) : Seals : Max. Speed (In/Sec) : Static Load Capacity (Lb.) : Carriage Width : Base Width (In.) : Carriage Hole Size (In.) :