Grainger.com

Technical Specification Item Steel Shaft Shaft Dia. 0.5 Dia. Tolerance Min. 0.4998 Dia. Tolerance Max. 0.4993 Mounting End Dia. (In.) 0.5 Thread Size 1/4-20 Thread Length (In.) 0.5 Length 18 Travel Length (In.) 18 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Dia. Tolerance Max. : 0.4993 in Base Height (mm) : - Shaft Dia. : 0.5 in Mounting End Dia. (mm) : - Dimension P : - Base Height (In.) : - Item : Steel Shaft Travel Length (In.) : 18 in Temp. Range (F) : 230 F Includes : - Bolt Size : - Dia. Tolerance Min. : 0.4998 in For Use With : - Material : Steel Base Width (mm) : - Dimension M : 1/4-20 Mounting Holes : - Thread Length (mm) : - Travel Length (mm) : - Finish : - Type : - Dimension Y : - Overall Height (mm) : - Dimension C : - Mounting Hole Center to Center : - Overall Height (In.) : - Dimension G : - Dimension L : 18.0 Mounting Surface to Shaft Center (In.) : - Mounting Hole from Shaft End : - Dimension E : - Thread Length (In.) : 0.5 in Dimension F : - Agency Compliance : - Dimension X : - Dimension B : 0.5 in Mounting Hole Size : - Min. Surface Hardness : 60 HRC Thread Size : 1/4-20 Mounting End Dia. (In.) : 0.5 in Length : 18 in Seals : Base Width : Carriage Width : Dimension W2 : Dimension W4 : Rail Height : Static Load Capacity (Lb.) : Rail Width (mm) : Max. Speed (m/Sec) : Running Clearance (In/mm) : Carriage Length : Rail Finish : Dimension L1 : Dimension H1 : Carriage Hole Size (mm) : Dimension L2 : Rail Material : Number of Rail Holes : Cnt Mtg Hole to Qualify Edge (In/mm) : Carriage Material : Dimension W3 : Dimension L3 : Dimension S X l (Carriage Hole Size) : Dynamic Load Capacity (Lb.) : Liner : Static Load Capacity (N) : Mounting Hole Center to Center (In/mm) : Dimension W : Rail Length : Max. Pv : Hole Size : Carriage Hole Size (In.) : Dynamic Load Capacity (N) : Base Width (In.) : Mounting Hole to End (In/mm) : Carriage Type : Dimension H4 : Dimension W1 : Max. Speed (In/Sec) :