Grainger.com

Technical Specification Item Steel Shaft Shaft Dia. 0.625 Dia. Tolerance Min. 0.6248 Dia. Tolerance Max. 0.6243 Mounting End Dia. (In.) 0.625 Thread Size 1/4-20 Thread Length (In.) 0.5 Length 36 Travel Length (In.) 36 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Thread Length (mm) : - Travel Length (mm) : - Dimension Y : - Dia. Tolerance Min. : 0.6248 in Dimension P : - Shaft Dia. : 0.625 in Base Width (mm) : - Base Height (mm) : - Length : 36 in Dimension M : 1/4-20 Material : Steel Temp. Range (F) : 230 F Dimension X : - Dimension F : - Finish : - Dimension B : 0.5 in Item : Steel Shaft Mounting Surface to Shaft Center (In.) : - For Use With : - Mounting Hole Center to Center : - Dimension L : 36.0 Mounting Hole from Shaft End : - Agency Compliance : - Mounting End Dia. (In.) : 0.625 in Mounting Holes : - Bolt Size : - Thread Length (In.) : 0.5 in Overall Height (mm) : - Type : - Mounting Hole Size : - Overall Height (In.) : - Travel Length (In.) : 36 in Dimension G : - Dia. Tolerance Max. : 0.6243 in Thread Size : 1/4-20 Includes : - Min. Surface Hardness : 60 HRC Mounting End Dia. (mm) : - Base Height (In.) : - Dimension E : - Dimension C : - Rail Material : Dimension W1 : Static Load Capacity (Lb.) : Number of Rail Holes : Max. Speed (In/Sec) : Seals : Carriage Hole Size (In.) : Dimension L1 : Dimension H : Mounting Hole Center to Center (In/mm) : Dimension W4 : Rail Height : Cnt Mtg Hole to Qualify Edge (In/mm) : Dimension H4 : Dynamic Load Capacity (N) : Rail Length : Base Width : Carriage Type : Dimension S X l (Carriage Hole Size) : Base Width (In.) : Carriage Length : Dimension W2 : Dimension W3 : Mounting Hole to End (In/mm) : Dimension D2 : Dynamic Load Capacity (Lb.) : Running Clearance (In/mm) : Max. Pv : Dimension L2 : Carriage Material : Carriage Width : Carriage Hole Size (mm) : Hole Size : Liner : Dimension L3 : Rail Width (mm) : Dimension W : Dimension H1 : Dimension D3 : Max. Speed