Grainger.com

Technical Specification Item Stainless Steel Shaft Shaft Dia. 0.5 Dia. Tolerance Min. 0.4998 Dia. Tolerance Max. 0.4993 Mounting End Dia. (In.) 0.5 Thread Size 1/4-20 Thread Length (In.) 0.5 Length 12 Travel Length (In.) 12 Temp. Range (F) 284 F Material Stainless Steel Min. Surface Hardness 56 HRC This listing is for each. Base Height (In.) : - Mounting Hole from Shaft End : - Material : Stainless Steel Dimension P : - Dimension G : - Item : Stainless Steel Shaft Travel Length (mm) : - Dimension M : 1/4-20 Min. Surface Hardness : 56 HRC Includes : - Dimension Y : - Overall Height (In.) : - Length : 12 in Temp. Range (F) : 284 F Base Height (mm) : - Mounting End Dia. (mm) : - Dimension C : - Mounting Hole Center to Center : - Thread Length (In.) : 0.5 in Travel Length (In.) : 12 in Bolt Size : - For Use With : - Agency Compliance : - Finish : - Mounting Surface to Shaft Center (In.) : - Dimension B : 0.5 in Dimension E : - Thread Size : 1/4-20 Dimension L : 12.0 Base Width (mm) : - Type : - Dimension F : - Shaft Dia. : 0.5 in Thread Length (mm) : - Dia. Tolerance Max. : 0.4993 in Overall Height (mm) : - Mounting End Dia. (In.) : 0.5 in Mounting Hole Size : - Dimension X : - Mounting Holes : - Dia. Tolerance Min. : 0.4998 in Seals : Dynamic Load Capacity (N) : Static Load Capacity (N) : Running Clearance (In/mm) : Mounting Hole to End (In/mm) : Base Width (In.) : Rail Width (mm) : Dimension H4 : Dimension W3 : Dimension H1 : Dimension L2 : Max. Speed (m/Sec) : Carriage Hole Size (mm) : Dimension D2 : Dimension N : Dynamic Load Capacity (Lb.) : Dimension L3 : Base Width : Carriage Type : Carriage Material : Dimension W : Static Load Capacity (Lb.) : Rail Height : Carriage Hole Size (In.) : Dimension D3 : Dimension S X l (Carriage Hole Size) : Hole Size : Dimension W2 : Rail Length : Liner : Carriage Width : Dimension L1 : Rail Material : Max. Speed (In/Sec) : Carriage Length : Number of Rail Holes : Carriage Height : Cnt Mtg Hole to Qualify Edge (In/mm) :