Grainger.com

Technical Specification Item Steel Shaft Shaft Dia. 0.75 Dia. Tolerance Min. 0.7497 Dia. Tolerance Max. 0.7492 Mounting End Dia. (In.) 0.5 Thread Size 1/2-13 Thread Length (In.) 0.63 Length 5 Travel Length (In.) 4 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Mounting Hole Center to Center : - Finish : - Dimension X : - Dimension F : 1 in Mounting End Dia. (mm) : - Includes : - Min. Surface Hardness : 60 HRC Overall Height (mm) : - Base Height (mm) : - Dia. Tolerance Max. : 0.7492 in Mounting Hole Size : - Item : Steel Shaft Mounting Holes : - Material : Steel Mounting End Dia. (In.) : 0.5 in Agency Compliance : - For Use With : - Overall Height (In.) : - Base Height (In.) : - Dia. Tolerance Min. : 0.7497 in Dimension B : 0.63 in Mounting Surface to Shaft Center (In.) : - Bolt Size : - Dimension C : - Thread Length (In.) : 0.63 in Thread Size : 1/2-13 Type : - Dimension Y : - Travel Length (In.) : 4 in Travel Length (mm) : - Dimension M : 1/2-13 Temp. Range (F) : 230 F Dimension E : - Length : 5 in Mounting Hole from Shaft End : - Thread Length (mm) : - Dimension G : 4.000 Dimension P : 0.5 in Dimension L : 5.0 Base Width (mm) : - Shaft Dia. : 0.75 in Running Clearance (In/mm) : Dimension W : Dimension D2 : Dimension H : Seals : Dimension L2 : Dimension H1 : Dimension W2 : Max. Pv : Carriage Type : Dimension L1 : Carriage Length : Carriage Width : Max. Speed (In/Sec) : Hole Size : Dimension L3 : Static Load Capacity (Lb.) : Dynamic Load Capacity (Lb.) : Rail Finish : Rail Height : Mounting Hole Center to Center (In/mm) : Dimension D3 : Carriage Hole Size (In.) : Dynamic Load Capacity (N) : Liner : Max. Speed (m/Sec) : Base Width (In.) : Dimension S X l (Carriage Hole Size) : Dimension W1 : Rail Width (mm) : Base Width : Rail Length : Mounting Hole to End (In/mm) : Cnt Mtg Hole to Qualify Edge (In/mm) : Rail Material : Carriage Height : Dimension W4 : Dimension W3 : Carriage Hole Size (mm) : Carriage Material