Grainger.com

Technical Specification Item Steel Shaft Shaft Dia. 0.75 Dia. Tolerance Min. 0.7497 Dia. Tolerance Max. 0.7492 Mounting End Dia. (In.) 0.5 Thread Size 1/2-13 Thread Length (In.) 0.63 Length 25 Travel Length (In.) 24 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Mounting End Dia. (mm) : - Overall Height (mm) : - Dimension X : - Mounting Holes : - Base Height (In.) : - Dia. Tolerance Min. : 0.7497 in Includes : - Mounting Hole Size : - Dimension C : - Overall Height (In.) : - Bolt Size : - Mounting Surface to Shaft Center (In.) : - Dia. Tolerance Max. : 0.7492 in Mounting Hole Center to Center : - Dimension G : 24.000 Dimension L : 25.0 Thread Length (mm) : - Mounting End Dia. (In.) : 0.5 in Shaft Dia. : 0.75 in Min. Surface Hardness : 60 HRC Type : - Length : 25 in Material : Steel Dimension M : 1/2-13 Agency Compliance : - Travel Length (mm) : - Dimension B : 0.63 in Dimension F : 1 in Dimension E : - Thread Length (In.) : 0.63 in Dimension P : 0.5 in Temp. Range (F) : 230 F Mounting Hole from Shaft End : - Base Height (mm) : - Item : Steel Shaft Finish : - Travel Length (In.) : 24 in Base Width (mm) : - Dimension Y : - For Use With : - Thread Size : 1/2-13 Dimension S X l (Carriage Hole Size) : Base Width (In.) : Carriage Length : Liner : Dimension W1 : Carriage Material : Hole Size : Mounting Hole to End (In/mm) : Max. Pv : Dimension L1 : Max. Speed (m/Sec) : Dimension H4 : Rail Finish : Rail Length : Cnt Mtg Hole to Qualify Edge (In/mm) : Dimension D2 : Carriage Height : Dynamic Load Capacity (Lb.) : Dimension L3 : Number of Rail Holes : Carriage Hole Size (In.) : Rail Material : Dimension W : Rail Width (mm) : Dimension W3 : Dimension W2 : Mounting Hole Center to Center (In/mm) : Carriage Hole Size (mm) : Dimension H : Seals : Static Load Capacity (Lb.) : Base Width : Carriage Type : Max. Speed (In/Sec) : Dimension W4 : Running Clearance (In/mm) : Dimension N : Carriage Width : Dimension L2 : Dimension