Whoops, we couldn't find that.

Technical Specification Item Steel Shaft Shaft Dia. 1.5 Dia. Tolerance Min. 1.4997 Dia. Tolerance Max. 1.499 Mounting End Dia. (In.) 1 Thread Size 1-8 Thread Length (In.) 1.25 Length 12 Travel Length (In.) 8 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Dimension Y : - Mounting End Dia. (mm) : - Finish : - Dimension E : - Dimension M : 1-8 Dimension B : - Dimension L : 12.0 Temp. Range (F) : 230 F Mounting Hole Center to Center : - Mounting Holes : - Shaft Dia. : 1.5 in Dimension X : - Type : - Mounting Hole from Shaft End : - Agency Compliance : - Dimension C : - For Use With : - Material : Steel Base Height (In.) : - Dimension F : 2 in Overall Height (mm) : - Mounting End Dia. (In.) : 1 in Mounting Hole Size : - Base Width (mm) : - Thread Length (In.) : 1.25 in Item : Steel Shaft Dia. Tolerance Max. : 1.499 in Travel Length (In.) : 8 in Bolt Size : - Mounting Surface to Shaft Center (In.) : - Dia. Tolerance Min. : 1.4997 in Includes : - Thread Length (mm) : - Base Height (mm) : - Thread Size : 1-8 Dimension P : 1 in Min. Surface Hardness : 60 HRC Length : 12 in Overall Height (In.) : - Travel Length (mm) : - Dimension G : 8.000 Dimension W3 : Hole Size : Liner : Dimension N : Dimension W : Dimension W2 : Dimension H : Max. Speed (In/Sec) : Dimension L1 : Running Clearance (In/mm) : Carriage Hole Size (mm) : Dimension W4 : Seals : Number of Rail Holes : Rail Height : Carriage Width : Rail Finish : Dimension D2 : Dimension H4 : Carriage Height : Max. Pv : Dimension W1 : Rail Width (mm) : Dimension H1 : Dimension L3 : Static Load Capacity (N) : Static Load Capacity (Lb.) : Dimension S X l (Carriage Hole Size) : Max. Speed (m/Sec) : Carriage Hole Size (In.) : Mounting Hole Center to Center (In/mm) : Carriage Length : Carriage Type : Base Width (In.) : Rail Length : Dimension D3 : Dynamic Load Capacity (N) : Dynamic Load Capacity (Lb.) : Mounting Hole to End (In/mm) : Base Width : Cnt Mtg Hole to Qualify Edge