Grainger.com

Technical Specification Item Steel Shaft Shaft Dia. 0.625 Dia. Tolerance Min. 0.6248 Dia. Tolerance Max. 0.6243 Mounting End Dia. (In.) 0.625 Thread Size 1/4-20 Thread Length (In.) 0.5 Length 18 Travel Length (In.) 18 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Mounting Surface to Shaft Center (In.) : - Mounting Hole Size : - Finish : - Travel Length (mm) : - Min. Surface Hardness : 60 HRC Thread Length (In.) : 0.5 in Agency Compliance : - Dia. Tolerance Min. : 0.6248 in Dimension F : - Dimension E : - Mounting Hole from Shaft End : - Includes : - Dimension B : 0.5 in Dimension M : 1/4-20 Material : Steel Type : - Mounting Holes : - Mounting End Dia. (mm) : - Shaft Dia. : 0.625 in Dimension G : - For Use With : - Overall Height (In.) : - Base Width (mm) : - Thread Length (mm) : - Dimension Y : - Base Height (In.) : - Dimension C : - Dimension L : 18.0 Dia. Tolerance Max. : 0.6243 in Travel Length (In.) : 18 in Mounting End Dia. (In.) : 0.625 in Item : Steel Shaft Mounting Hole Center to Center : - Thread Size : 1/4-20 Bolt Size : - Dimension X : - Length : 18 in Temp. Range (F) : 230 F Dimension P : - Base Height (mm) : - Overall Height (mm) : - Dimension S X l (Carriage Hole Size) : Seals : Carriage Height : Max. Pv : Cnt Mtg Hole to Qualify Edge (In/mm) : Dimension W1 : Running Clearance (In/mm) : Dimension H1 : Carriage Material : Static Load Capacity (Lb.) : Dimension D2 : Dimension H : Rail Length : Mounting Hole Center to Center (In/mm) : Mounting Hole to End (In/mm) : Rail Width (mm) : Dimension W4 : Base Width : Static Load Capacity (N) : Hole Size : Dimension W : Max. Speed (In/Sec) : Dynamic Load Capacity (N) : Number of Rail Holes : Carriage Type : Rail Material : Rail Height : Dimension L3 : Dimension D3 : Base Width (In.) : Dynamic Load Capacity (Lb.) : Carriage Length : Dimension N : Carriage Width : Carriage Hole Size (In.) : Dimension L2 : Dimension H4 : Rail Finish : Max. Speed (m/Sec) :