Shaft,Steel,0.625 In D,36.00 In

Technical Specification Item Steel Shaft Shaft Dia. 0.625 Dia. Tolerance Min. 0.6248 Dia. Tolerance Max. 0.6243 Mounting End Dia. (In.) 0.625 Thread Size 1/4-20 Thread Length (In.) 0.5 Length 36 Travel Length (In.) 36 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Dimension M : 1/4-20 Finish : - Agency Compliance : - Mounting Holes : - For Use With : - Travel Length (mm) : - Thread Length (In.) : 0.5 in Mounting End Dia. (mm) : - Temp. Range (F) : 230 F Thread Size : 1/4-20 Mounting Hole from Shaft End : - Type : - Dimension B : 0.5 in Bolt Size : - Mounting End Dia. (In.) : 0.625 in Dimension X : - Thread Length (mm) : - Overall Height (In.) : - Base Width (mm) : - Includes : - Dimension C : - Item : Steel Shaft Min. Surface Hardness : 60 HRC Shaft Dia. : 0.625 in Dimension G : - Dimension Y : - Overall Height (mm) : - Dimension F : - Dimension P : - Dia. Tolerance Min. : 0.6248 in Base Height (mm) : - Base Height (In.) : - Travel Length (In.) : 36 in Mounting Surface to Shaft Center (In.) : - Length : 36 in Mounting Hole Center to Center : - Dimension L : 36.0 Dimension E : - Mounting Hole Size : - Material : Steel Dia. Tolerance Max. : 0.6243 in Seals : Dimension H4 : Rail Length : Dimension L2 : Base Width : Rail Height : Liner : Number of Rail Holes : Carriage Hole Size (In.) : Carriage Width : Dimension S X l (Carriage Hole Size) : Running Clearance (In/mm) : Static Load Capacity (N) : Dynamic Load Capacity (Lb.) : Hole Size : Static Load Capacity (Lb.) : Carriage Length : Carriage Type : Rail Material : Base Width (In.) : Dimension N : Dimension L1 : Dimension W1 : Dimension L3 : Dimension D3 : Max. Pv : Dimension W : Carriage Height : Dimension W3 : Max. Speed (In/Sec) : Rail Finish : Dynamic Load Capacity (N) : Dimension D2 : Dimension H : Carriage Material : Mounting Hole to End (In/mm) : Dimension H1 : Dimension W4 : Cnt Mtg Hole to Qualify Edge (In/mm) : Mounting Hole Center to Center (In/mm) :