Shaft,Steel,0.750 In D,12.00 In

Technical Specification Item Steel Shaft Shaft Dia. 0.75 Dia. Tolerance Min. 0.7497 Dia. Tolerance Max. 0.7492 Mounting End Dia. (In.) 0.75 Thread Size 5/16-18 Thread Length (In.) 0.625 Length 12 Travel Length (In.) 12 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Mounting End Dia. (mm) : - Dimension L : 12.0 Dimension C : - Dia. Tolerance Min. : 0.7497 in Type : - Finish : - Min. Surface Hardness : 60 HRC Dimension F : - Base Height (In.) : - Dimension Y : - Mounting Holes : - Dimension M : 5/16-18 Travel Length (In.) : 12 in Overall Height (In.) : - Travel Length (mm) : - Mounting Surface to Shaft Center (In.) : - Overall Height (mm) : - Agency Compliance : - Length : 12 in Material : Steel Dimension E : - Mounting End Dia. (In.) : 0.75 in Mounting Hole Size : - Base Height (mm) : - For Use With : - Dimension X : - Thread Length (In.) : 0.625 in Temp. Range (F) : 230 F Thread Size : 5/16-18 Dimension B : 0.625 in Mounting Hole from Shaft End : - Mounting Hole Center to Center : - Dia. Tolerance Max. : 0.7492 in Base Width (mm) : - Dimension P : - Includes : - Dimension G : - Thread Length (mm) : - Item : Steel Shaft Shaft Dia. : 0.75 in Bolt Size : - Dimension H4 : Dimension W4 : Max. Speed (m/Sec) : Carriage Length : Carriage Type : Rail Height : Seals : Rail Width (mm) : Carriage Hole Size (In.) : Base Width : Dynamic Load Capacity (Lb.) : Dimension L2 : Dimension L1 : Running Clearance (In/mm) : Dimension H1 : Dimension D2 : Dimension L3 : Rail Finish : Carriage Width : Dimension D3 : Number of Rail Holes : Static Load Capacity (Lb.) : Dimension W2 : Rail Material : Dimension W1 : Dimension H : Dimension S X l (Carriage Hole Size) : Hole Size : Base Width (In.) : Dimension W : Rail Length : Max. Speed (In/Sec) : Max. Pv : Carriage Hole Size (mm) : Carriage Material : Dynamic Load Capacity (N) : Cnt Mtg Hole to Qualify Edge (In/mm) : Carriage Height : Dimension W3 : Static Load Capacity (N) : Liner :