Grainger.com

Technical Specification Item Steel Shaft Shaft Dia. 0.75 Dia. Tolerance Min. 0.7497 Dia. Tolerance Max. 0.7492 Mounting End Dia. (In.) 0.5 Thread Size 1/2-13 Thread Length (In.) 0.63 Length 13 Travel Length (In.) 12 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Overall Height (In.) : - Dimension X : - Dimension C : - Mounting End Dia. (In.) : 0.5 in Mounting Holes : - Dimension E : - Mounting Surface to Shaft Center (In.) : - Travel Length (mm) : - Agency Compliance : - Overall Height (mm) : - Length : 13 in Dimension Y : - Dimension B : 0.63 in Item : Steel Shaft Bolt Size : - Type : - Thread Size : 1/2-13 Thread Length (In.) : 0.63 in Mounting Hole from Shaft End : - Dimension F : 1 in For Use With : - Mounting End Dia. (mm) : - Dia. Tolerance Min. : 0.7497 in Base Height (In.) : - Dimension P : 0.5 in Thread Length (mm) : - Base Height (mm) : - Dimension L : 13.0 Dia. Tolerance Max. : 0.7492 in Includes : - Base Width (mm) : - Finish : - Dimension G : 12.000 Min. Surface Hardness : 60 HRC Dimension M : 1/2-13 Material : Steel Mounting Hole Center to Center : - Shaft Dia. : 0.75 in Mounting Hole Size : - Travel Length (In.) : 12 in Temp. Range (F) : 230 F Static Load Capacity (N) : Dimension D2 : Rail Length : Carriage Length : Dimension W1 : Dimension H4 : Dimension W : Seals : Dimension N : Running Clearance (In/mm) : Dimension D3 : Base Width : Mounting Hole to End (In/mm) : Rail Material : Carriage Height : Cnt Mtg Hole to Qualify Edge (In/mm) : Carriage Hole Size (In.) : Max. Pv : Carriage Type : Max. Speed (m/Sec) : Mounting Hole Center to Center (In/mm) : Dimension L3 : Dimension W2 : Carriage Width : Hole Size : Dynamic Load Capacity (N) : Dimension L2 : Dynamic Load Capacity (Lb.) : Dimension H : Dimension L1 : Dimension W4 : Liner : Dimension H1 : Carriage Hole Size (mm) : Base Width (In.) : Carriage Material : Dimension W3 : Rail Width (mm) : Static Load Capacity (Lb.) : Dimension S X l