Grainger.com

Technical Specification Item Steel Shaft Shaft Dia. 0.75 Dia. Tolerance Min. 0.7497 Dia. Tolerance Max. 0.7492 Mounting End Dia. (In.) 0.75 Thread Size 5/16-18 Thread Length (In.) 0.625 Length 36 Travel Length (In.) 36 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Dimension G : - Finish : - Dimension E : - Dimension Y : - Mounting End Dia. (mm) : - Mounting Holes : - Mounting Hole Center to Center : - Mounting End Dia. (In.) : 0.75 in Min. Surface Hardness : 60 HRC Dimension C : - Mounting Hole Size : - Type : - Shaft Dia. : 0.75 in Dimension B : 0.625 in Dia. Tolerance Min. : 0.7497 in Base Height (mm) : - Travel Length (mm) : - Dimension P : - Thread Length (mm) : - Length : 36 in Base Width (mm) : - Mounting Surface to Shaft Center (In.) : - Mounting Hole from Shaft End : - Bolt Size : - For Use With : - Travel Length (In.) : 36 in Thread Size : 5/16-18 Base Height (In.) : - Item : Steel Shaft Dimension X : - Dimension L : 36.0 Dia. Tolerance Max. : 0.7492 in Includes : - Material : Steel Overall Height (In.) : - Overall Height (mm) : - Temp. Range (F) : 230 F Dimension M : 5/16-18 Agency Compliance : - Dimension F : - Thread Length (In.) : 0.625 in Dimension L1 : Dimension N : Dimension H4 : Rail Width (mm) : Number of Rail Holes : Dimension D2 : Mounting Hole to End (In/mm) : Base Width : Carriage Material : Carriage Height : Liner : Dimension W4 : Dimension D3 : Rail Material : Dimension L2 : Carriage Type : Seals : Hole Size : Dimension W2 : Dimension S X l (Carriage Hole Size) : Rail Length : Cnt Mtg Hole to Qualify Edge (In/mm) : Max. Speed (m/Sec) : Dimension W3 : Carriage Hole Size (mm) : Dimension H : Dimension W1 : Base Width (In.) : Carriage Width : Rail Finish : Rail Height : Dimension H1 : Dimension L3 : Static Load Capacity (Lb.) : Dimension W : Carriage Length : Max. Pv : Dynamic Load Capacity (N) : Static Load Capacity (N) : Max. Speed (In/Sec) : Running Clearance (In/mm) : Dynamic Load