Shaft,Steel,1.000 In D,25.25 In

Technical Specification Item Steel Shaft Shaft Dia. 1 Dia. Tolerance Min. 0.9997 Dia. Tolerance Max. 0.9992 Mounting End Dia. (In.) 0.625 Thread Size 5/8-11 Thread Length (In.) 0.78 Length 25.25 Travel Length (In.) 24 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. For Use With : - Finish : - Dimension F : 1.25 in Mounting Holes : - Mounting Hole Center to Center : - Dimension Y : - Mounting End Dia. (In.) : 0.625 in Dia. Tolerance Max. : 0.9992 in Base Height (mm) : - Type : - Dimension C : - Min. Surface Hardness : 60 HRC Mounting Hole from Shaft End : - Dimension E : - Mounting Surface to Shaft Center (In.) : - Thread Length (mm) : - Item : Steel Shaft Base Height (In.) : - Dimension M : 5/8-11 Travel Length (In.) : 24 in Includes : - Temp. Range (F) : 230 F Length : 25.25 in Dimension L : 25.25 Mounting Hole Size : - Material : Steel Base Width (mm) : - Thread Size : 5/8-11 Overall Height (In.) : - Mounting End Dia. (mm) : - Overall Height (mm) : - Dimension B : 0.78 in Travel Length (mm) : - Dia. Tolerance Min. : 0.9997 in Thread Length (In.) : 0.78 in Agency Compliance : - Shaft Dia. : 1 in Dimension G : 24.000 Bolt Size : - Dimension X : - Dimension P : 0.625 in Dimension L2 : Carriage Length : Dynamic Load Capacity (Lb.) : Dimension H : Running Clearance (In/mm) : Carriage Type : Liner : Dimension D3 : Max. Pv : Rail Material : Seals : Mounting Hole Center to Center (In/mm) : Rail Length : Carriage Material : Dimension W3 : Carriage Width : Static Load Capacity (N) : Hole Size : Dimension H1 : Dimension L1 : Cnt Mtg Hole to Qualify Edge (In/mm) : Dimension W4 : Dimension W2 : Carriage Height : Rail Height : Mounting Hole to End (In/mm) : Static Load Capacity (Lb.) : Carriage Hole Size (In.) : Dynamic Load Capacity (N) : Base Width : Base Width (In.) : Max. Speed (In/Sec) : Carriage Hole Size (mm) : Dimension W1 : Dimension S X l (Carriage Hole Size) : Rail Finish : Dimension H4 : Number of Rail Holes :