Shaft,Steel,1.250 In D,18.00 In

Technical Specification Item Steel Shaft Shaft Dia. 1.25 Dia. Tolerance Min. 1.2497 Dia. Tolerance Max. 1.249 Mounting End Dia. (In.) 1.25 Thread Size 1/2-13 Thread Length (In.) 1 Length 18 Travel Length (In.) 18 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Bolt Size : - Dimension Y : - Includes : - Temp. Range (F) : 230 F Base Height (In.) : - Min. Surface Hardness : 60 HRC Mounting Hole Center to Center : - Overall Height (mm) : - Dimension P : - Mounting Surface to Shaft Center (In.) : - Material : Steel For Use With : - Mounting Holes : - Thread Size : 1/2-13 Mounting Hole from Shaft End : - Dia. Tolerance Min. : 1.2497 in Dimension F : - Shaft Dia. : 1.25 in Mounting End Dia. (mm) : - Dimension L : 18.0 Dimension M : 1/2-13 Dimension G : - Base Width (mm) : - Travel Length (In.) : 18 in Dia. Tolerance Max. : 1.249 in Item : Steel Shaft Dimension E : - Length : 18 in Base Height (mm) : - Travel Length (mm) : - Dimension C : - Finish : - Overall Height (In.) : - Dimension B : 1 in Thread Length (mm) : - Mounting End Dia. (In.) : 1.25 in Agency Compliance : - Mounting Hole Size : - Thread Length (In.) : 1 in Dimension X : - Type : - Max. Pv : Hole Size : Carriage Type : Dimension W1 : Rail Width (mm) : Dimension H4 : Rail Material : Dimension L1 : Carriage Material : Carriage Length : Rail Finish : Static Load Capacity (Lb.) : Dimension H : Mounting Hole to End (In/mm) : Dynamic Load Capacity (Lb.) : Dimension W : Dimension H1 : Liner : Dimension D2 : Base Width : Mounting Hole Center to Center (In/mm) : Cnt Mtg Hole to Qualify Edge (In/mm) : Dimension W2 : Dimension N : Carriage Hole Size (mm) : Dimension W3 : Dimension D3 : Dimension S X l (Carriage Hole Size) : Rail Length : Rail Height : Static Load Capacity (N) : Carriage Height : Carriage Width : Base Width (In.) : Dynamic Load Capacity (N) : Seals : Carriage Hole Size (In.) : Running Clearance (In/mm) : Dimension L3 : Dimension W4 : Max. Speed