Shaft,Steel,1.250 In D,6.00 In

Technical Specification Item Steel Shaft Shaft Dia. 1.25 Dia. Tolerance Min. 1.2497 Dia. Tolerance Max. 1.249 Mounting End Dia. (In.) 1.25 Thread Size 1/2-13 Thread Length (In.) 1 Length 6 Travel Length (In.) 6 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Dimension L : 6.0 Includes : - Thread Length (mm) : - Dimension X : - Shaft Dia. : 1.25 in Temp. Range (F) : 230 F Dimension B : 1 in Base Height (mm) : - Base Height (In.) : - Dimension M : 1/2-13 Dia. Tolerance Max. : 1.249 in Overall Height (mm) : - Item : Steel Shaft Dia. Tolerance Min. : 1.2497 in Mounting End Dia. (In.) : 1.25 in For Use With : - Mounting Hole Size : - Mounting Holes : - Finish : - Agency Compliance : - Dimension E : - Material : Steel Dimension G : - Mounting End Dia. (mm) : - Min. Surface Hardness : 60 HRC Dimension C : - Mounting Hole Center to Center : - Thread Length (In.) : 1 in Dimension P : - Length : 6 in Mounting Hole from Shaft End : - Bolt Size : - Travel Length (mm) : - Mounting Surface to Shaft Center (In.) : - Travel Length (In.) : 6 in Base Width (mm) : - Dimension Y : - Type : - Thread Size : 1/2-13 Overall Height (In.) : - Dimension F : - Dimension W : Dimension L2 : Carriage Length : Static Load Capacity (Lb.) : Liner : Dimension L1 : Dimension H1 : Dimension N : Rail Width (mm) : Dimension D2 : Rail Length : Dimension W4 : Number of Rail Holes : Seals : Base Width : Base Width (In.) : Mounting Hole Center to Center (In/mm) : Carriage Hole Size (mm) : Dimension W2 : Dimension W1 : Carriage Hole Size (In.) : Mounting Hole to End (In/mm) : Dynamic Load Capacity (Lb.) : Dimension S X l (Carriage Hole Size) : Dimension W3 : Dimension H4 : Dimension L3 : Dynamic Load Capacity (N) : Static Load Capacity (N) : Running Clearance (In/mm) : Carriage Material : Hole Size : Max. Speed (In/Sec) : Cnt Mtg Hole to Qualify Edge (In/mm) : Dimension H : Max. Pv : Max. Speed (m/Sec) : Rail Finish : Dimension D3 : Carriage Width :