Shaft,Steel,1.500 In D,14.00 In

Technical Specification Item Steel Shaft Shaft Dia. 1.5 Dia. Tolerance Min. 1.4997 Dia. Tolerance Max. 1.499 Mounting End Dia. (In.) 1 Thread Size 1-8 Thread Length (In.) 1.25 Length 14 Travel Length (In.) 12 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Base Width (mm) : - Travel Length (mm) : - Agency Compliance : - Includes : - For Use With : - Dimension X : - Mounting Holes : - Thread Size : 1-8 Base Height (In.) : - Mounting End Dia. (mm) : - Dimension L : 14.0 Shaft Dia. : 1.5 in Dimension C : - Dimension E : - Mounting End Dia. (In.) : 1 in Overall Height (mm) : - Overall Height (In.) : - Temp. Range (F) : 230 F Travel Length (In.) : 12 in Thread Length (mm) : - Mounting Hole Size : - Dimension Y : - Dia. Tolerance Min. : 1.4997 in Dimension B : 1.25 in Bolt Size : - Type : - Mounting Surface to Shaft Center (In.) : - Dimension P : 1 in Dimension M : 1-8 Material : Steel Length : 14 in Dimension F : 2 in Thread Length (In.) : 1.25 in Mounting Hole Center to Center : - Base Height (mm) : - Finish : - Min. Surface Hardness : 60 HRC Dia. Tolerance Max. : 1.499 in Dimension G : 12.000 Item : Steel Shaft Mounting Hole from Shaft End : - Dimension W3 : Dimension H : Rail Material : Dimension L3 : Liner : Carriage Length : Mounting Hole to End (In/mm) : Dimension D3 : Rail Height : Max. Speed (m/Sec) : Max. Pv : Dimension L1 : Dynamic Load Capacity (N) : Cnt Mtg Hole to Qualify Edge (In/mm) : Carriage Type : Carriage Hole Size (mm) : Dimension N : Base Width : Dimension S X l (Carriage Hole Size) : Rail Width (mm) : Static Load Capacity (Lb.) : Carriage Width : Rail Finish : Dimension W2 : Base Width (In.) : Rail Length : Mounting Hole Center to Center (In/mm) : Dimension H1 : Hole Size : Static Load Capacity (N) : Carriage Height : Dimension H4 : Dimension D2 : Seals : Max. Speed (In/Sec) : Dimension W4 : Dimension L2 : Carriage Hole Size (In.) : Carriage Material : Dynamic Load Capacity (Lb.) : Running