Grainger.com

Technical Specification Item Steel Shaft Shaft Dia. 1.5 Dia. Tolerance Min. 1.4997 Dia. Tolerance Max. 1.499 Mounting End Dia. (In.) 1.5 Thread Size 5/8-11 Thread Length (In.) 1.25 Length 24 Travel Length (In.) 24 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Overall Height (mm) : - Dimension C : - Finish : - Dimension G : - Dimension B : 1.25 in Thread Size : 5/8-11 Agency Compliance : - Base Width (mm) : - Dimension F : - Dimension P : - Dimension Y : - Mounting Holes : - Thread Length (mm) : - Mounting Hole from Shaft End : - Dia. Tolerance Max. : 1.499 in Material : Steel Item : Steel Shaft Travel Length (mm) : - Type : - Thread Length (In.) : 1.25 in Dia. Tolerance Min. : 1.4997 in Dimension E : - Travel Length (In.) : 24 in Mounting Hole Size : - Base Height (In.) : - Shaft Dia. : 1.5 in Temp. Range (F) : 230 F Mounting Hole Center to Center : - Mounting Surface to Shaft Center (In.) : - Dimension M : 5/8-11 Base Height (mm) : - Dimension X : - Mounting End Dia. (In.) : 1.5 in For Use With : - Overall Height (In.) : - Mounting End Dia. (mm) : - Includes : - Dimension L : 24.0 Length : 24 in Bolt Size : - Min. Surface Hardness : 60 HRC Static Load Capacity (N) : Dynamic Load Capacity (N) : Seals : Dimension N : Carriage Hole Size (mm) : Rail Length : Cnt Mtg Hole to Qualify Edge (In/mm) : Dimension D3 : Dimension W1 : Dimension W4 : Dimension L3 : Base Width : Dimension H4 : Rail Width (mm) : Carriage Hole Size (In.) : Carriage Type : Hole Size : Static Load Capacity (Lb.) : Carriage Width : Mounting Hole Center to Center (In/mm) : Number of Rail Holes : Carriage Material : Max. Pv : Dimension L1 : Dimension S X l (Carriage Hole Size) : Liner : Dimension L2 : Running Clearance (In/mm) : Max. Speed (In/Sec) : Dimension D2 : Dimension H : Rail Finish : Max. Speed (m/Sec) : Base Width (In.) : Dimension W3 : Dynamic Load Capacity (Lb.) : Rail Height : Dimension W : Carriage Height : Dimension W2 : Rail