Shaft,Steel,0.250 In D,6.00 In

Technical Specification Item Steel Shaft Shaft Dia. 0.25 Dia. Tolerance Min. 0.2498 Dia. Tolerance Max. 0.2494 Mounting End Dia. (In.) 0.25 Thread Size #5-40 Thread Length (In.) 0.25 Length 6 Travel Length (In.) 6 Temp. Range (F) 230 F Material Steel Min. Surface Hardness 60 HRC This listing is for each. Dimension L : 6.0 Mounting Hole Size : - Overall Height (In.) : - Base Height (mm) : - Thread Length (mm) : - Thread Length (In.) : 0.25 in Dimension P : - Overall Height (mm) : - Dimension X : - Base Width (mm) : - Travel Length (mm) : - Dimension E : - For Use With : - Type : - Finish : - Dimension F : - Min. Surface Hardness : 60 HRC Agency Compliance : - Mounting Holes : - Dimension Y : - Shaft Dia. : 0.25 in Mounting Surface to Shaft Center (In.) : - Dimension B : 0.25 in Bolt Size : - Travel Length (In.) : 6 in Length : 6 in Thread Size : #5-40 Mounting End Dia. (mm) : - Material : Steel Mounting End Dia. (In.) : 0.25 in Temp. Range (F) : 230 F Dimension G : - Mounting Hole from Shaft End : - Mounting Hole Center to Center : - Dia. Tolerance Max. : 0.2494 in Includes : - Item : Steel Shaft Base Height (In.) : - Dimension C : - Dimension M : #5-40 Dia. Tolerance Min. : 0.2498 in Dimension W1 : Rail Width (mm) : Mounting Hole to End (In/mm) : Number of Rail Holes : Max. Speed (m/Sec) : Seals : Dimension N : Rail Material : Dimension H1 : Max. Pv : Dimension S X l (Carriage Hole Size) : Carriage Height : Carriage Material : Static Load Capacity (N) : Dimension D3 : Dimension H : Mounting Hole Center to Center (In/mm) : Dimension W : Cnt Mtg Hole to Qualify Edge (In/mm) : Dynamic Load Capacity (N) : Static Load Capacity (Lb.) : Carriage Type : Dimension W3 : Carriage Hole Size (In.) : Carriage Width : Base Width : Dynamic Load Capacity (Lb.) : Rail Length : Dimension L3 : Dimension H4 : Rail Height : Dimension L2 : Liner : Dimension W2 : Dimension W4 : Max. Speed (In/Sec) : Rail Finish : Hole Size : Running Clearance (In/mm) : Carriage Hole Size (mm)